Connecting An External Scsi Accessory - HP Kayak XA User Manual

NOTE

Connecting an External SCSI Accessory

If you have a SCSI-based system, your PC Workstation is equipped with
an Ultra wide 16-bit SCSI connector for internal devices and an Ultra
narrow 8-bit SCSI connector for external devices. An external SCSI
device is connected as follows:
1 You should assign an unused SCSI address to the accessory. SCSI
addresses range from 0 to 7 for narrow 8-bit SCSI and from 0 to 15
for wide 16-bit SCSI, with SCSI address 0 used by the first SCSI hard
disk drive and SCSI address 7 reserved for the integrated SCSI
controller (the default for narrow and wide SCSI devices).
Refer to the manual provided with the SCSI accessory for
instructions on selecting a SCSI address.
You don't need to set a SCSI address for Plug and Play SCSI devices
(SCSI devices which support the SCAM protocol).
2 Using a shielded SCSI cable, connect the SCSI accessory to your PC
Workstation's external 8-bit SCSI connector. The SCSI connector is
next to the LAN connector (refer to the graphic on page 5).
3 Make sure the SCSI accessory is terminated correctly—either
internally or by a terminating resistor (refer to the manual provided
with the SCSI accessory).
To PC Workstation
4 Refer to the manual provided with the SCSI accessory to learn how
to install any software that may be necessary to use it.
1 Setting Up and Using Your PC Workstation
Connecting an External SCSI Accessory
Make sure the SCSI
accessory is terminated
correctly
English 9