If An Accessory Board Does Not Work - HP Kayak XA User Manual

3 Troubleshooting Your PC Workstation
If Your PC Workstation Has a Hardware Problem
If the CD-ROM Drive Door Does Not Open
If you have difficulty removing a CD-ROM disk from the CD-ROM drive
(during a power failure for example), you can use the manual eject
button. To eject a CD-ROM disk using the manual eject button,
proceed as follows:
1 If the CD-ROM drive manual eject button is not visible, remove the
2 With a thin, solid rod, such as the end of a paper clip, push the
The picture shows two
possible locations of the
manual eject button.
3 The CD-ROM drive door is released, opening slightly. Carefully pull
4 To close the CD-ROM drive door, push it gently closed without
5 If required, replace the CD-ROM drive's front bezel.

If an Accessory Board Does Not Work

•
•
•
70
front bezel covering the CD-ROM drive. The manual eject button is
inside a small hole on the front of the CD-ROM drive.
CD-ROM's manual eject button.
it open fully and retrieve the disk.
forcing it. The CD-ROM drive door may not close completely until it
is fully functional (for example, when the power comes back on).
Check that the accessory board has been firmly installed in the slot.
Check that the accessory board has been correctly configured.
Check that the accessory board is not using memory, I/O addresses,
an IRQ, or DMA also used by the PC Workstation. Refer to page 81
for more information. Refer to the board's manual for further details.
English