Installing A Hard Disk Drive In The Top Rear Shelf - HP Kayak XA User Manual

CAUTION
Some SCSI disk drives may have termination resistors that must be
removed or disabled before installation in your PC Workstation. Refer
to the drive's installation guide for more details and to see if there is a
special installation procedure to follow.

Installing a Hard Disk Drive in the Top Rear Shelf

The top rear shelf is located under the power supply. This shelf
probably already has a LAN board or a SCSI/LAN board installed in the
corresponding slot. If this is the case, or indeed if any PCI board has
been installed in the slot, you cannot install a hard disk drive in the
shelf. If the shelf is free, you can install a 3.5-inch hard disk drive.
Handle the hard disk drive with care. Avoid shocks and violent
movement as this can cause damage to the hard disk drive's internal
components.
Make sure that you back up your files before you install a hard disk
drive. Refer to your operating system documentation for information on
how to do this.
1 Turn off the display and computer, and disconnect the power supply
cords and any connection to a telecommunications network.
2 Remove the computer's cover (refer to page 27) and move the power
supply unit (refer to page 29).
2 Installing Accessories in Your PC Workstation
Installing Mass Storage Devices
English 37