6. Connect the fan tray power connector (
Lock it by pushing it slightly upwards while pressing the locking clip to the right
with a screwdriver.
7. Connect the system indicator board connector to the receptacle at the top of the
fan tray. Replace the retaining clip (
Connector
Clip
FIGURE 6-8
8. Remove the wrist strap.
9. Close the front doors to the system.
6.3
IB Fans
Two IB fans (I/O assembly fans) supply cooling for this unit.
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
Caution – This procedure requires the system to be extended out of the system
cabinet on its slides. Before attempting this procedure you must deploy system
cabinet stabilization devices, if fitted.
Replacing the System Indicator Board Connector Retaining Clip
).
FIGURE 6-5
).
FIGURE 6-8
Chapter 6 Cooling Subsystem
6-13