Hints And Tips - Sandstrom SDWTTB14E Installation Instructions Manual

Hints and Tips

• Repairs should only be carried out by a qualified technician in strict accordance with current local and
national safety regulations. Unauthorised or incorrect repairs could cause personal injury or damage to
the unit.
• Before calling for service, please refer to the section Hints and Tips to solve some general problems by
yourself.
General Issues
Issue
Detergent residue is left in
the dispenser at the end of
the programme.
The detergent dispenser lid
cannot be closed properly.
Knocking noise in the wash
cabinet.
Smearing appears on
glassware and cutlery.
Dishes, cutlery and glasses
are not dry.
White residue is visible
on cutlery and crockery,
clouding occurs on
glassware; film can be wiped
off.
Glassware is dull and
discoloured; film cannot be
wiped off.
Tea or lipstick stains have
not been completely
removed.
General Problems
Possible Causes
The detergent dispenser was still
damp when detergent was added.
Clogged detergent residue is
blocking the catch.
A spray arm is knocking against an
item in a basket.
The rinse aid dosage is set too high.
The amount of rinse aid may be
insufficient, or the rinse aid reservoir
is almost empty.
Crockery was taken out of the
dishwasher too soon.
Not enough rinse aid was used.
There is not enough salt in the salt
reservoir.
The salt reservoir cap has not been
screwed on correctly.
Unsuitable detergent has been used.
The salt consumption setting is too
low.
The glassware is not dishwasher
proof. The surfaces are affected.
The wash temperature of the selected
programme was too low.
The bleaching effect of the detergent
used is too low.
Forgot to pre-rinse or remove the
stains with a napkin prior to washing.
Solution
Make sure the dispenser is dry before
adding detergent.
Clean the catch.
Interrupt the programme, and
rearrange the items which are
obstructing the spray arm. See the
section Loading the Dishwasher.
Adjust the dial of the rinse aid
dispenser to a lower setting.
Replenish the reservoir, adjust the rinse
aid dispenser dial to a higher setting or
change the brand of rinse aid.
Leave the crockery in the dishwasher
until you hear an audible sound.
Replenish the reservoir, adjust the rinse
aid dispenser dial to a higher setting or
change the brand of rinse aid.
Fill the salt reservoir.
Ensure that it is screwed back on
correctly.
Change your detergent. Use a
dishwasher standard powder
detergent.
Select a higher salt consumption
setting.
Wash the non-dishwasher proof
glassware by hand.
Select a programme with a higher
wash temperature.
Change your detergent.
Pre-rinse or remove the stains with a
napkin prior to washing.
GB
37 37