Switching Off The Unit; Unloading The Dishwasher; Delay Start; Cleaning After Use - Sandstrom SDWTTB14E Installation Instructions Manual

Switching Off the Unit

To save energy, remember to switch the dishwasher off using the
dishwasher will continue to use electricity until it is switched off with the
GB
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect the unit
from the mains supply.

Unloading the Dishwasher

Allowing dishes to cool down before unloading is important as dishes tend to break and chip
more easily when they are hot. Therefore, if you open the dishwasher door fully after switching
off, it will allow the dishes to cool down much faster.
Unload the lower basket first, followed by the cutlery basket and then the upper basket. This will prevent
water drops from the upper basket from falling on to the dishes in the lower basket.

Delay Start

The starting time of a washing programme can be delayed and adjusted. Please follow the steps
below.
1. Open the dishwasher door and load your soiled dishes and crockery.
2. Close the door. Press the
3. Select your preferred programme.
4. Press the
hours).
Each press of this button increases the delay start time by 3 hours increments.
5. Press the
automatically.

Cleaning After Use

External Care

The Door and the Door Seal

Clean the door seals regularly with a soft damp cloth to remove food deposits.
When the dishwasher is being loaded, food and drink residues may drip onto the sides of the
dishwasher door. These surfaces are outside the wash cabinet and are not accessed by water
from the spray arms. Any deposits should be wiped off before the door is closed.
34 34
On/Off button to turn on the dishwasher.
Delay button repeatedly to select your desired delay period (range up to 12
Start/Pause button and the unit will start the programme at the assigned time
On/Off button. The
On/Off button.