Adding Rinse Aid; Adjusting The Rinse Aid Reservoir - Sandstrom SDWTTB14E Installation Instructions Manual

Adding Rinse Aid

Rinse aid helps to ensure water does not cling and leave marks on crockery during the drying
phase and helps crockery dry faster after it has been washed. Only pour rinse aid that is for
domestic dishwashers into the reservoir. This model is designed to use liquid rinse aids only.
Please follow the steps below to pour the rinse aid into the storage reservoir, and the amount
will dispense automatically.
1. Turn the cap and open as indicated.
2. When the cap open marking is aligned,
you may lift the cap up.
3. Pour the rinse aid until the rinse aid
indicator turns completely black in colour
and close the cap.
4. Be careful not to overfill the reservoir.
Wipe up any spills.
• If the water hardness in your area is soft, you may not need rinse aid as it may cause white film to develop
on your dishes.
• If you decide to use a detergent tablet, you do not need to add rinse aid into the rinse aid reservoir.
• Rinse aid refill warning indicator will illuminate when the reservoir is running out of rinse aid and requires
refilling.
• Alternatively, you can judge the amount of rinse aid by checking the rinse aid indicator next to the
reservoirs cap when the indicator is black, it means it is full. When it is clear, it means it is almost empty.

Adjusting the Rinse Aid Reservoir

The rinse aid reservoir has six settings. Both the recommended setting and the factory setting
is "4". If the dishes are not drying properly or are spotted, adjust the dial to the next higher
number until your dishes are spot-free.
If there is rinse aid residue left in the washing compartment or on your dishes, turn the rinse aid dispenser
dial to 1.
GB
4 3 2
5
1
6
27 27