Hints And Tips; Technical Problems - Sandstrom SID60W12N Installation Instructions Manual

Hints and Tips

• Repairs should only be carried out by a qualified technician in strict accordance with current local
and national safety regulations. Unauthorised or incorrect repairs could cause personal injury or
damage to the unit.
• Before calling for service, please refer to the section Hints and Tips to solve some general
problems by yourself.

Technical Problems

Problem
The dishwasher does not start.
GB
Error code "E1" displayed.
Error code "E4" displayed.
Error code "E8" displayed.
The drain pump is not working
properly.
Problem
Detergent residue is left in the
dispenser at the end of the
programme.
The detergent dispenser lid
cannot be closed properly.
Knocking noise in the wash
cabinet.
Smearing appears on
glassware and cutlery.
46
Technical Problems
Possible Causes
The door is not properly
closed.
The unit is not connected to
the mains socket.
The unit is not switched on.
Longer inlet time.
Overflow.
Failure of orientation of
distributary valve.
The anti-flooding system has
operated.
General Problems
Possible Causes
The detergent dispenser was
still damp when detergent was
added.
Clogged detergent residue is
blocking the catch.
A spray arm is knocking
against an item in a basket.
The rinse aid dosage is set too
high.
Remedy
Close the door firmly.
Connect the mains plug to the mains
socket.
On/Off button and select
Press the
a programme.
• Fauces is not open.
• Water intake is restricted.
• Water pressure is too low.
• Some element of dishwasher
leaks.
• Open circuit or break of
distributary valve.
• Disconnect from the mains socket.
• Disconnect the water inlet.
• Call a qualified technician.
Remedy
Make sure the dispenser is dry before
adding detergent.
Clean the catch.
Interrupt the programme, and
rearrange the items which are
obstructing the spray arm. See the
section Loading the Dishwasher.
Adjust the dial of the rinse aid
dispenser to a lower setting.