Using Numeric Keys; Specifying Destinations - Canon imageCLASS D1120 Basic Operation Manual

Specifying Destinations

Specifying Destinations
This section describes how to specify a fax destination. You can select a destination stored
in the Address Book, a one-touch key or coded dial code, or you can specify a new
destination.

Using Numeric Keys

You can specify a new fax number using
[numeric keys] and
1
Place documents.
2
Press [SEND/FAX]/
3
Press [SEND/FAX] repeatedly to
select <FAX>, then press [OK].
F A X
S E L E C T : O K
For the D1150, skip this step.
– ,
[Tone].
[FAX].
4
Use – , [numeric keys] and
[Tone] to enter the fax number.
Ex.
F A X N U M B E R
T E L = 0 1 2 X X X X X X X
If you entered a wrong number when specifying
a fax number, go back to the wrong digit with
.
If <CONFIRM FAX NO.> in <ACCESS TO DEST.> in
<SYSTEM SETTINGS> is set to <ON> and you
specify a fax number using
keys] and [Tone], you need to enter the fax
number again for confirmation. Enter the same fax
number you entered in step 4, then press [OK].
5
Press [Start].
– When you place the documents on the platen
glass, press
size, then press
When scanning is complete, press [OK] to
start sending.
– You can also adjust the following scan
settings as necessary, using the keys on the
operation panel, after specifying the
destination in step 4.
• Density: See "Adjusting Density, " on p. 6-29.
• Image Quality: See "Selecting Image Quality, "
on p. 6-30.
• 2-Sided: See "2-Sided Documents, " on p. 6-
31.
– , [numeric
or to select the document
[Start] for each document.
6-19