ChangNg DensTy Level; Changing Density Level - Canon imageCLASS D1120 Basic Operation Manual

Changing Density Level

Changing Density Level
This setting enables you to preset the standard density level on a nine-step scale. The
default setting is <5> on a scale of 1 to 9. The level you define here applies when you select
the "standard" level (in the middle of the scale) using
1
Press [Menu].
2
Press or
SETTINGS>, then press [OK].
M E N U
4 . T X / R X
3
Press or
COMMON SET.>, then press [OK].
T X / R X
2 . T X / R X
4
Press or
then press [OK].
T X / R X
1 . T X
5
Press or
DENSITY>, then press [OK].
T X S E T T I N G S
4 . S C A N N I N G
6-34
to select <TX/RX
S E T T I N G S
to select <TX/RX
S E T T I N G S
C O M M O N S E T .
to select <TX SETTINGS>,
C O M M O N S E T .
S E T T I N G S
to select <SCANNING
D E N S I T Y
[Density] on the operation panel.
6
Press or
then press [OK].
S C A N N I N G
- L T
– : to make light documents darker
– : to make documents lighter
7
Press [Stop/Reset] to return to the
standby mode.
to adjust the density,
D E N S I T Y
D K +