Table of Contents
Advertisement
10 TUNING THE CHASSIS
10.15
10.16
40
Handlebar position
C00248-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
C00249-10
Info
Turn clockwise to increase the damping; turn
counterclockwise to reduce damping when the shock
absorber rebounds.
On the upper triple clamp, there are 2 holes at a distance of
to each other.
A
15 mm (0.59 in)
Hole distance
The holes on the handlebar supports are placed at a distance
B
of
from the center.
B
3.5 mm (0.138 in)
Hole distance
The handlebar supports can be mounted in four different posi-
tions. This allows the handlebar to be mounted in the most com-
fortable position for the rider.
–
1
Remove screws
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
2
Remove screws
. Take off handlebar supports.
–
Place handlebar supports in required position. Mount and
2
tighten screws
.
Guideline
Screw, handle-
M10
bar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
evenly.
A
40 Nm (29.5 lbf ft)
®
Loctite
243™
1
and tighten
Advertisement
Chapters
Table of Contents
