Husqvarna TC 50 2023 Owner's Manual page 94

12 BRAKE SYSTEM
92
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly posi-
tioned in the holding spring.
–
Position the brake caliper on the brake disc.
The brake linings are correctly positioned.
–
F02167-10
Attach the brake line to holder
–
Mount and tighten screw
Guideline
Screw, rear
brake caliper
–
Mount and tighten screw
Guideline
Screw, rear
brake caliper
F02163-10
–
Mount and tighten screw
Guideline
Screw, brake lin-
ings
–
Mount lock ring
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
–
Add brake fluid up to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
H01654-10
–
Position cover with washer and membrane.
–
Mount and tighten the screws.
Info
Use water to immediately clean up any brake fluid that
has overflowed or spilled.
Finishing work
–
Remove the motorcycle from the lift stand. (
5
.
3
.
M6x16 10 Nm (7.4 lbf ft)
Loctite
4
.
M6x40 10 Nm (7.4 lbf ft)
Loctite
2
.
M5 8 Nm (5.9 lbf ft)
1
.
A
.
10 mm (0.39 in)
p. 137)
p. 42)
® 243™
®
243™