Husqvarna TC 50 2023 Owner's Manual page 84

12 BRAKE SYSTEM
82
Warning
Skin irritation Brake fluid causes skin irritation.
–
Keep brake fluid out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
–
Consult a doctor immediately if brake fluid has been swallowed.
–
Rinse the affected area with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact
with the eyes.
–
If brake fluid spills on to your clothing, change the clothing.
Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
Warning
Danger of accidents Brake linings which have not been approved alter the braking efficiency.
Not all brake linings are tested and approved for Husqvarna motorcycles. The structure and friction
coefficient of the brake linings, and thus their brake power, may vary greatly from that of original brake
linings.
If brake linings are used that differ from the original equipment, compliance with the original homolo-
gation is not guaranteed. In this case, the vehicle no longer corresponds to its condition at delivery
and the manufacturer warranty shall be void.
–
Only use brake linings approved and recommended by Husqvarna motorcycles.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
V02100-10
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
–
1
Remove screws .
–
2
Take off cover with membrane
p. 42)
3
.