Husqvarna TC 50 2023 Owner's Manual page 92

12 BRAKE SYSTEM
90
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
F02164-10
F02207-10
F03004-11
F02207-11
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
(TC 50)
–
1
Remove lock ring
–
2
Remove screw .
–
3
Remove screw and screw
–
Take off the brake caliper.
Info
Do not kink or damage the brake line.
–
Remove the brake linings.
–
Clean the brake caliper and the brake caliper bracket.
–
Allow the brake caliper and the brake line to hang loosely
to the side.
–
Check the brake discs. (
–
5
Remove screws .
–
6
Take off cover with washer
–
Press the brake piston back into the basic position and
ensure that brake fluid does not flow out of the brake fluid
reservoir, extracting some if necessary.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly posi-
tioned in the holding spring.
–
Position the brake caliper on the brake disc.
The brake linings are correctly positioned.
p. 42)
.
4
.
p. 78)
7
and membrane
8
.