Husqvarna TC 50 2023 Owner's Manual page 38

10 TUNING THE CHASSIS
36
Info
If the spring cannot be fully released, the spring
must be removed to accurately measure the
spring length.
–
Measure the total spring length while the spring is not
under tension.
–
Tighten the spring to the specified measurement by turn-
ing adjusting ring
Guideline
Spring preload
Info
The spring preload is the difference between the
relaxed spring length and the tensioned spring
length.
Depending on the static sag and/or the riding sag,
it may be necessary to increase or decrease the
spring preload.
–
Tighten retaining ring
(TC 50 MINI)
–
Measure the full spring length while it is under tension
and note down the value.
–
Loosen retaining ring
–
Turn adjusting ring
tension.
Hook wrench (T304)
Hook wrench (T1533)
F02187-10
Info
If the spring cannot be fully released, the spring
must be removed to accurately measure the
spring length.
–
Measure the total spring length while the spring is not
under tension.
–
Tighten the spring to the specified measurement by turn-
ing adjusting ring
Guideline
Spring preload
Standard
Info
The spring preload is the difference between the
relaxed spring length and the tensioned spring
length.
Depending on the static sag and/or the riding sag,
it may be necessary to increase or decrease the
spring preload.
–
Tighten retaining ring
2
.
3 mm (0.12 in)
1
.
1
.
2
until the spring is no longer under
2
.
5 mm (0.2 in)
1
.