Table of Contents
Advertisement
Startup
Startup
1. See Load fluid with feed pumps in HFR operation
manual.
2. Open feed pump air regulator.
3. Open feed pump bleed-type master air valve.
4. Adjust air to feed pump with needle valve.
NOTE:
•
Cold, viscous material may be difficult to prime.
Use needle valve to reduce air flow to motor.
•
Do not plug or shut off pump fluid outlet when
priming. Fluid must be free to flow through
pump to prime.
•
To increase pump flow rate and reduce icing,
remove pump muffler. This will increase exhaust
noise.
5. Never let pump run when drum is empty. A dry
pump can accelerate and damage itself. If pump is
running too fast, stop it immediately. Check and refill
fluid supply, or flush with compatible solvent. Always
prime entire system to remove any air. Do not let
material harden in pump.
16
Shutdown
See Shutdown in system operation manual. Close feed
pump bleed-type master air valve.
Pressure Relief
Procedure
1. If the optional drum feed kit is being used, remove
the air pressure from the Husky pump.
2. See Pressure Relief Procedure in system opera-
tion manual.
Maintenance
Drum Feed Kit - Air Dryer
Replace silica gel units when the desiccant color or
moisture indicator has changed color from Blue (mean-
ing dry) to Pink (meaning wet).
There is a sight window on the side of the canister to
allow viewing of the desiccant color.
1. Loosen the clamp ring and remove the desiccant
canister from the rubber housing.
2. Apply tape over the both ends of the canister.
3. Discard used canister.
4. Remove sticky tabs from the ends of the new canis-
ter to allow airflow.
5. Install canister into the rubber housing to allow view-
ing of the sight window.
NOTE: Make sure the arrows found on the canister point
into the rubber housing.
6. Tighten the clamp ring.
3A2806A
Advertisement
Table of Contents
