Remote Datatrak Operation; Startup; Run Mode - Graco S20 Operation

Remote DataTrak Operation

NOTICE
To prevent damage to soft key buttons, do not press
the buttons with sharp objects such as pens, plastic
cards, or fingernails.

Startup

1. Perform the Start and Adjust Ram procedure on
page 22, and the Start and Adjust Pump
procedure on page 24.
If the air motor slider valve (BF) is open when the
remote DataTrak is powered on, the air supply to the
motor will automatically turn on via activation of the
air solenoid (X) when the display changes from the
Splash Screen to Run Mode. Make sure the air motor
slider valve is closed before turning the remote
DataTrak power on to prevent serious injury from
moving parts.
2. Close the air motor slider valve (BF) before turning
the remote DataTrak power on.
3. Turn on the remote DataTrak system using the
rocker switch on the ram power supply.
Rocker
Switch
F . 25
IG
4. The Splash Screen (F
progress bar fills from left to right. It will then go
directly to Run Mode (F
5. Follow the Start and Adjust Pump procedure in the
pump manual.
313526S
. 26) will flash on while the
IG
. 27).
IG
F . 26: Splash Screen
IG

Run Mode

See F . 24 and F . 27.
IG IG
The Run Mode screen displays the resettable job total
counter (JT), maintenance counter (MC), cycle/flow rate
(CF), and the remaining volume in the drum (DV) in both
numeric and icon versions.
NOTE: All items are displayed using the defined volume
units (VU).
DV
CF
F . 27: Run Mode Screen
IG
Key Functions When in Run Mode
1. To enter Prime Mode, press and release
2. To enter Setup Mode (page 30), press and hold
for 3 seconds.
3. To enter Diagnostic Mode (page 33), press and
release . The system will enter Diagnostic Mode
only if there are active warnings/alarms.
4. To reset the job total counter, press and hold
from Run Mode for 3 seconds.
Remote DataTrak Operation
JT
MC
.
29