Units; Key Beep; All Measures; Data Access - Teledyne CP Series User Manual

User Manual
CP Series
Version 3.1 – June 2020
between 5 and 255 seconds. Any value below or above these limits will automatically be adjusted to the
nearest limit.
5.4.15 U
NITS
Set your preferred unit system, metric or imperial, by pressing the 'OK'
button (15) while the 'Units' menu item is highlighted.
5.4.16 K
EY BEEP
An audible feedback (beep) can be enabled or disabled by selecting the
'Key beep' menu and pressing the 'OK' button (15).
5.5 A
LL MEASURES
The 'All measures' menu displays the most important measurements
in 1 screen and updates them in real time, even while making an
exposure. This will allow for easy monitoring of the main
environmental and generator parameters and assist in analyzing
conditions that lead to warning or error conditions. The displayed
measurements are:
• Real time measurement of kV [kV] and mA [mA]
Duty cycle of the kV inverter [%] and current drawn by the filament [mA]
•
• Frequency of the kV inverter [Hz] and the filament inverter [Hz]
Temperature of the kV inverter [i°C], the ambient air in the PowerModule [a°C] and the SF6
•
pressure [bar]
Temperature of the SF6 gas [s°C] and radiator of the generator [r°C]
•
• Input voltage (AC) [V] and frequency [Hz], ambient temperature in the PowerBox [a°C]
Internal 50Vdc [V], current consumption [A] and radiator temperature [r°C]
•
380 Vdc High Voltage power supply [V] and current consumption [A]
•
5.6 D
ATA ACCESS
At the beginning and at the end of each shot, a series of data and
measurements is registered in the CP200 generator and the PowerBox.
This data can be accessed via the PowerBox. The data stored in the
PowerBox can be downloaded to a USB drive for archiving or failure
analyses.
Settings

Units

metric
Settings

Key beep

0.1kV 0.01mA
10% 0mA
45000Hz 146192H
i 29°C a 29°C 6.1bar
s 29°C r 27°C
230.0V 50Hz a 34°C
50.2V 0.27A r 28°C
1.4V 0.00A

Data Access

PowerBox
Generator
ON
47