Advertisement
FIGURE 5
13
TIGHTEN!
BLACK 27
STEP 5:
• SECURELY assemble the PULLEY BOOM (3) to the TOWER (1) and the REAR UPRIGHT (4) using two 3/8 X 73mm BOLTS (18),
four 3/8" FLAT WASHERS (39) and two 3/8" LOW HEIGHT LOCK NUTS (24) as shown in FIGURE 5.
• Slide the 13/16" SHAFT COLLARS (13) up against the PULLEY BOOM (3) and SECURELY tighten the set screws on the SHAFT
COLLARS (13). See FIGURE 5.
• SECURELY assemble the two BAR SUPPORTS (6) to the BASE FRAME (2) using four BLACK RH CAPS (27), four RH CAPS (28),
four 3/8 X 43mm BOLTS (16), eight 3/8" SAE WASHERS (25), four 3/8" RH WASHERS (26) and four 3/8" LOW HEIGHT LOCK
NUTS (24) as shown in FIGURE 5.
24
4
39
1
6
25 26
16 3/8 X 43mm
3
18 3/8 X 73mm
2
9
27 BLACK
28
24
Advertisement
