Advertisement
FIGURE 10
STEP 10:
• Route the BI/TRI CABLE (29) between two 4-1/2" PULLEYS (7) and SECURELY assemble the 4-1/2" PULLEYS (7) to the BASE FRAME
(2) using four RH CAPS (28), two 3/8 X 90mm BOLTS (20), four 3/8" SAE WASHERS (25), four 3/8" RH WASHERS (26), four 3/8 X 1"
FLANGE SPACERS (15) and two 3/8" LOW HEIGHT LOCK NUTS (24) as shown in FIGURE 10.
FIGURE 11
STEP 11:
• SECURELY assemble one 3/8 X 86mm retaining BOLT (19) to the BASE FRAME (2) using two 3/8" SAE WASHERS (25), two 3/8" RH
WASHERS (26), one 3/8" LOW HEIGHT LOCK NUT (24) and two RH CAPS (28) as shown in FIGURE 11. (NOTE: Make sure the BI/
TRI CABLE (29) runs in the groove of the PULLEY.)
7
15
26
25
28
3/8 X 90mm 20
26
25
28
3/8 X 86mm 19
13
29
24
2
29
24
2
Advertisement
