Cab Display Module (Cdm); Cab Display Module (Cdm) Programming - MacDon M155E4 2016 Manual

4 Cab Display Module (CDM)

Although the other procedures in this manual are intended to be followed in the order in which they are listed,
the sections in the "Cab Display Module (CDM)" chapter can be referred to in any order according to your
specific requirements.

4.1 Cab Display Module (CDM) Programming

Figure 4.1: CDM
A - Side Display
D - Menu Item Scroll Forward
Side Display: Displays software revision status.
• Upper Line – C### (CDM)
• Lower Line – E### (WCM)
Main Display: Displays menu item and selection
• Upper Line – Menu Item
• Lower Line – Selection
Select Switch: Places monitor into Program Mode with program switch. Press to accept menu item and advance
to next item.
Menu Item Scroll Forward: Displays value under menu item.
• Push to scroll forward
• Hold down for fast scroll
4. The current selection is flashing.
5. Fast scroll applies only when changing KNIFE SPEED, OVERLOAD PRESSURE, and TIRE SIZE.
147764
B - Main Display
E - Menu Item Scroll Backward
4 .
5
C - Select Switch
F - Program Switch
67
Revision A