Setting The Return To Cut Mode - MacDon M155E4 2016 Manual

4. Press SELECT (D) until HEADER INDEX MODE? is
displayed on the upper line.
• REEL & CONVEYOR or REEL ONLY is displayed
on the lower line.
5. Press left (B) or right (C) arrows to set header index
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.

4.4.8 Setting the Return to Cut Mode

NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header. For more information, refer to
page 26.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode.
• WINDROWER SETUP? is displayed on the
upper line.
• NO/YES is displayed on the lower line.
3. Press right (B) arrow to select YES. Press SELECT (C).
• SET KNIFE SPEED? is displayed.
4. Press SELECT (D) until RETURN TO CUT MODE? is
displayed on the upper line.
• HEIGHT & TILT or HEIGHT ONLY will be displayed
on the lower line.
5. Press left (B) or right (C) arrows to select return to cut
mode. Press SELECT (D).
6. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.
147764
CAB DISPLAY MODULE (CDM)
Figure 4.42: Header Index Mode
Figure 4.43: CDM Programming Buttons
Figure 4.44: Return to Cut Mode
87
3.10 Attaching Headers,
Revision A