Activating The Draper Speed Control Lockout - MacDon M155E4 2016 Manual

4. Press SELECT (B) until SET CONTROL LOCKS? is
displayed on the upper line.
• NO/YES is displayed on the lower line.
5. Press right (A) arrow to select YES. Press SELECT (B).
6. Press SELECT (D) until HEADER FLOAT is displayed
on the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7. Press left arrow (B) to enable HEADER FLOAT control
switch, or press right arrow (C) to lock HEADER FLOAT
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.

4.5.4 Activating the Draper Speed Control Lockout

NOTE:
• This procedure is for draper headers only.
• The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
147764
CAB DISPLAY MODULE (CDM)
Figure 4.70: Control Locks
Figure 4.71: Header Float Control Lock
99
Revision A