Operational Checks; Engine Warning Lights; Start Engine; Engine Speed - MacDon M Series Unloading And Assembly Instructions

K. OPERATIONAL CHECKS
I. ENGINE WARNING LIGHTS
a. Turn ignition key to RUN position.
b. Single loud tone sounds, and engine warning
lights illuminate.
II. START ENGINE
Refer to STEP 20. START ENGINE, and then
proceed as follows:
1. The brakes should engage, and the machine
should not move after engine start-up.
M150, M200 SHOWN - M100 SIMILAR
2. Ensure the steering wheel is centered. Move
GSL (A) straight out of N-DETENT (neither
forward nor reverse). The machine should not
move.
3. With the GSL out of N-DETENT, check that
the steering wheel is free to move.
4. If the machine does not function as described
above, the system requires adjustment. Refer
to the Technical Service Manual.
III. ENGINE SPEED
a. Check engine rpm on CDM.
IDLE
M100 1100
M150 1100
M200 1100
Form 169242
PRE-DELIVERY CHECKS
A
MAX RPM (No Load)
2630 - 2650
2270 - 2330
2250 - 2300
IV. GUAGES AND CDM DISPLAY
a. Check engine temperature gauge and fuel gauge
are working.
DISPLAY
Engine / Windrower Functions
b. Check CDM display is working by pushing
SELECT on CDM, or SELECT button on GSL.
V. ELECTRICAL
Push the SELECT button on GSL, or SELECT
switch on CDM to display VOLTS. The display
indicates the condition of the battery and
alternator. Refer to following table.
IGNITION ENGINE
Running
On
Shutdown
Display flashes voltage reading with
single loud tone. Repeats every 30
minutes until condition fixed.
84
INDICATED
READING
CONDITION
13.8 - 15.0 Normal.
> 16.0
Regulator Out
of Adjustment.
See Note.
Alternator Not
Working,
< 12.5
OR
See Note.
Regulator Out
of Adjustment.
12.0 Battery Normal.
NOTE
(continued next page)
Revision D