Installing A Network Card - HP Brio 8172 Upgrade Manual

Troubleshooting
If the new card is not recognized, check that you have correctly followed the installation procedure described above.
If there are any errors reported during the computer's startup routine, press the
and take any necessary action(s).
If you experience any other problems as a result of the upgrade, refer to the online support center.

Installing a Network Card

This section contains additional expansion card information describing how to install a "10BaseT" type of network card
such as the one supplied in the HP network kit.
Caution
Installing the Card
1 Install the card as described in steps 1 to 7 of
2 Replace the airflow guide and the cover, and reconnect the power supply cords. Do not turn on the computer yet as
this may cause an error message to be displayed indicating that there is a problem with the network card—which is not
true.
3 Connect one end of the network cable to the back of the network card, and the other end of the cable to the network
hub.
Static electricity can damage electronic components. Turn off all equipment. Don't let your clothes touch the
accessory. To equalize the static electricity, rest the accessory bag on top of the computer while you are removing
the accessory from the bag. Handle the accessory as little as possible and with care.
"Installing an Expansion Card" on page
2 Installing Accessories in Your Computer
Installing Expansion Cards
key to view the error(s),
36.
38