Table of Contents
Advertisement
5 Secure the drive to the box using the two screws provided with the drive. One screw must be inserted in each side.
Using screws other than those provided may cause damage to the device.
6 Connect the power and data cables to the rear of the drive. The connectors are shaped to fit one way only. Refer to
"System Board Connectors" on page 44
7 Replace the power supply unit and secure it using the four screws.
8 Install any other accessories before replacing the cover and reconnecting the power cords and any telecommunications
cables.
9 Turn on the display, let it warm up, and then turn on the computer. Press the
at the bottom of the screen. This displays a summary screen showing the computer's configuration details. Check that
the new drive is recognized.
Before you can use the new hard disk drive, you will probably need to set up partitions and then format the drive. To
do this, restart your computer in MS-DOS mode, run fdisk to set up the partitions, restart the computer, and then
format the new drive from within Windows 95.
Troubleshooting
If the new drive is not recognized, you may need to run the Setup program: restart the computer and press the
If the new drive is still not recognized, check that you have correctly followed the installation procedure described
above.
If there are any errors reported during the computer's startup routine, press the
and take any necessary action(s).
If you cannot start your computer properly, remove the new drive and try starting your computer again. If the computer
now starts OK, there may be a problem with the new drive.
If you experience any other problems as a result of the upgrade, refer to the online support center.
key while F2=Setup is displayed.
for more information about which connectors to use.
2 Installing Accessories in Your Computer
Installing Storage Devices
key while F2=Setup is displayed
key to view the error(s),
51
Advertisement
Table of Contents
