Installing An Additional 3.5-Inch Hard Disk Drive - HP Brio 8172 Upgrade Manual

Installing an Additional 3.5-inch Hard Disk Drive

Refer to the drive's manual(s) to see if you must set jumpers or if there is a special installation procedure to follow.
Note
Installing the Drive
1 Remove the computer's cover (refer to
2 Unscrew and remove the access plate on the rear of the computer.
3 Pass the drive through the shelf (with the connectors pointing towards the front of the computer).
4 Secure the drive to the computer using the four screws provided with the drive. Two screws must be inserted in each
side. Using screws other than those provided may cause damage to the device.
5 Resecure the access plate on the rear of the computer.
If your new hard disk drive already has a mounting tray attached, you must remove it before you can install the drive
in your computer.
Step 2
"Removing the Cover" on page
2 Installing Accessories in Your Computer
22).
Step 3
Installing Storage Devices
46