Changing Advanced Settings - Grizzly G0931 Owner's Manual

Running G-Code From Controller
Internal Memory
1.
Press RUN/PAUSE.
2.
Scroll to "Internal File" and press OK, then
scroll to G-code file and press OK.
3.
Screen will display "SetWorkParam" and the
following parameters:
— WorkSpd (feed rate in mm/sec.).
— FastSpd (movement speed between cuts
in mm/sec.).
— SpdScale (spindle speed ratio).
— FallDown (Z-axis speed ratio).
4.
Scroll to desired parameter and press RUN/
PAUSE to change value, then press OK.
5.
Press OK again to begin operation.
— Press RUN/PAUSE to pause axis move-
ment. Spindle will continue to spin. Axes
can be manually moved while paused.
Press RUN/PAUSE again to resume, then
OK to resume from new axis position, or
STOP to return to original position.
— Press Y+ and Y- during operation to
manually change spindle speed ratio from
0.1 (stopped) to 1.0 (full speed).
— Press STOP to completely stop operation.
Choose between "Save break" to save
breakpoint to return to later, or "Discard
break" to stop operation without saving.
Resume saved processing through the
advanced processing menu (see Using
Advanced Controls on Page 34).
Model G0931 (Mfd. Since 02/21)
Changing Advanced
Settings
Changing advanced settings will change the
default functions of your machine and how
it processes files. Changing advanced set-
tings is only recommended for experienced
operators. After changing settings, monitor
machine operation carefully to prevent dam-
age to the machine, workpiece, or cutter.
Many advanced functions of the G0931 are turned
off by default. Notably, S and F letter addresses
are ignored until turned on in the controller.
Most advanced settings are accessible through
the "AUTO PRO SETUP" menu.
F-Code Processing
1. Press MENU, then scroll to "AUTO PRO
SETUP" and press OK.
2. Scroll to "G Code Setup" and press OK.
3. Scroll to "F Read" and press RUN/PAUSE.
"Ign F" will change to "Read F". Press OK to
save.
S-Code Processing
1.
Press MENU, then scroll to "AUTO PRO
SETUP" and press OK.
2. Scroll to "G Code Setup" and press OK.
3. Scroll to "S Read" and press RUN/PAUSE.
"Ign S" will change to "Read S". Press OK to
save.
-33-