Connecting Controller - Grizzly G0931 Owner's Manual

Connecting
Controller
The Model G0931 includes a RichAuto A11 hand-
held motion controller that controls all machine
functions using G-code. The RichAuto control
system uses an interface board located in the
electrical cabinet (see Figure 13), a 50-pin data
transmission cable, and a USB-B communication
cable for digital connections.
To connect controller:
1.
Open electrical cabinet on machine (see
Figure 13).
Figure 13. Electrical cabinet location.
-20-
2. Connect 50-pin cable to interface board in
electrical cabinet, then route cable through
hole in cabinet floor (see Figure 14).
Figure 14. 50-pin cable connected to interface
board.
3.
Connect opposite end of 50-pin cable to
controller (see Figure 15).
Figure 15. Controller connected to cable.
Model G0931 (Mfd. Since 02/21)
50-Pin Cable
Connector
Interface Board