Changing Advanced Settings; Using Advanced Controls - Grizzly G0894 Owner's Manual

— Press Y+ and Y- during operation to
manually change spindle ratio. Spindle
ratio ranges from 0.1 (stopped) to 1.0 (full
speed).
— Press STOP to completely stop operation.
Choose between "Save break" to save
breakpoint to return to later, or "Discard
break" to stop operation without saving.
Resume saved processing through the
advanced processing menu (see Using
Advanced Controls on this page).
Changing Advanced
Settings
Changing advanced settings will change the
default functions of your machine and how
it processes files. Changing advanced set-
tings is only recommended for experienced
operators. After changing settings, monitor
machine operation carefully to prevent dam-
age to the machine, workpiece, or cutter.
Many advanced functions of the G0894 are turned
off by default. Notably, S and F letter addresses
are ignored until turned on in the controller.
Most advanced settings are accessible through
the "AUTO PRO SETUP" menu.
To turn on F-code processing:
1. Press MENU, then scroll to "AUTO PRO
SETUP" and press OK.
2. Scroll to "G Code Setup" and press OK.
3. Scroll to "F Read" and press RUN/PAUSE.
"Ign F" will change to "Read F". Press OK to
save.
-30-
To turn on S-code processing:
1. Press MENU, then scroll to "AUTO PRO
SETUP" and press OK.
2. Scroll to "G Code Setup" and press OK.
3.
Scroll to "S Read" and press RUN/PAUSE.
"Ign S" will change to "Read S". Press OK to
save.
Using Advanced
Controls
All the basic controls of the G0894 are performed
through single-button commands on the control-
ler, but some advanced features require multi-
button commands to access.
Advanced Processing Menu
Advanced tool functions are accessed through the
advanced processing menu. Functions include
array work, resuming stopped jobs, surfacing a
workpiece, calculating bounds of a file, and calcu-
lating processing time of a file.
To access advanced processing menu:
1.
Hold down RUN/PAUSE, then press HIGH/
LOW and release buttons together.
Switching Coordinate Systems
Up to nine work coordinate systems can be saved
at a time. When work origin is set, it is set for the
active coordinate system. If the absolute coordi-
nate system is active, work origin cannot be set.
To access advanced processing menu:
1.
Hold down MENU, then press one 0-9 num-
ber button and release buttons together.
— Press MENU + 0 to activate absolute coor-
dinate system (mechanical coordinates).
— Press MENU + 1-9 to activate work coor-
dinate systems.
Model G0894 (Mfd. Since 05/19)