Table of Contents
Advertisement
I
Figure 5. Z-axis tool setter.
I.
Z-Axis Tool Setter: Establishes Z-axis origin
based on surface tool setter is placed on.
Controller Functions
The following commands are used for the basic
navigation of the machine and controller. Additional
functions can be accessed with multi-button
commands (see Using Advanced Controls on
Page 34) for more information.
Figure 6. Controller buttons.
X+ or 1: Moves spindle motor along X-axis in
positive direction. Scrolls menu up. Input for "1".
Y+ or 2: Moves spindle motor along Y-axis in
positive direction. Increases feed rate. Scrolls
sub-menu up. Input for "2".
Model G0931 (Mfd. Since 02/21)
Z+ or 3: Moves spindle motor along Z-axis in
positive direction. Increases spindle speed during
process. Input for "3".
XY->0 or 4: Sets work origin of X- and Y-axes
(see Page 30). Input for "4".
X- or 5: Moves spindle motor along X-axis in neg-
ative direction. Scrolls menu down. Input for "5".
Y- or 6: Moves spindle motor along Y-axis in
negative direction. Decreases feed rate. Scrolls
sub-menu down. Input for "6".
Z- or 7: Moves spindle motor along Z-axis in nega-
tive direction. Decreases spindle speed during
process. Input for "7".
Z->0 or 8: Sets work origin of Z-axis (see
Page 30). Input for "8".
HOME or 9: Returns all axes to home position
(see Page 30). Input for "9".
HIGH/LOW or 0: In manual mode, selects high or
low speed for axis movement. Input for "0".
ON/OFF or (.): Turns spindle ON or OFF. Input
for decimal point.
MENU or (-): Enters setup menus. Input for the
negative symbol.
ORIGIN or OK: Returns all axes to work origin
(see Page 30). Confirms motions, inputs, or
operations.
MODE: Toggles between the three jogging modes:
Continuous, Step, or Distance.
RUN/PAUSE or DELETE: Runs or pauses pro-
cessing. Use to load a program from either the
USB drive or internal memory.
STOP or CANCEL: Stops a running program.
Cancels commands.
-5-
Advertisement
Table of Contents
