Setting Stepper Driver Dip Switches - Grizzly G0931 Owner's Manual

Setting Stepper
Driver DIP Switches
The DIP (Dual In-line Package) switches on the
stepper drivers control the step size, current, and
speed of the stepper motors. If the DIP switches
are not configured properly, erroneous signals will
cause the stepper motors to function incorrectly.
To set stepper driver DIP switches:
1. DISCONNECT MACHINE FROM POWER!
2. Open electrical cabinet and locate (3) stepper
driver DIP switches (see Figure 48).
Figure 48. Stepper driver DIP switch locations.
Model G0931 (Mfd. Since 02/21)
3. Compare each stepper driver DIP switch con-
figuration to diagram in Figure 49.
— If DIP switch does match diagram, DIP
switch is set correctly.
— If DIP switch does not match diagram, flip
individual rocker switches until DIP switch
matches diagram.
Rocker
Switch
Figure 49. DIP switch configuration.
4.
Close electrical cabinet and proceed to
Test Run on Page 22 to verify machine
functions properly.
DIP
Switch
-47-