Table of Contents
Advertisement
Verifying Parameters
Machine parameters are essential to any operation.
If the parameters are wrong, the machine will not
produce accurate results, and damage to the
machine and workpiece may occur.
Verify machine parameters before running
any operation whenever machine is pow-
ered ON. Parameters can be changed or
lost when power cycling occurs, and operat-
ing with incorrect parameters may result in
damage to machine or workpiece.
Verifying Default Parameters
The machine parameters have been set at the
factory, but they can be changed or lost due to
hardware, software, or power issues. Consult this
section to verify and reset parameters.
To verify default parameters:
1.
Press MENU on the controller, then scroll to
Machine Setup and press OK.
2.
Scroll to each parameter shown on this page
and press OK to verify.
— To change a parameter, press RUN/
PAUSE, then enter the new parameter.
Press OK to save.
Model G0931 (Mfd. Since 02/21)
Pulse Equivalent:
X Equival ................................................ 200.000
Y Equival ................................................ 200.000
Z Equival ................................................. 400.000
Table Size:
X Size ................................................... 1300.000
Y Size ....................................................1190.000
Z Size ....................................................... 90.000
Home Setup
Home Speed (Unit MM/Sec.)
X Spd .................................................... 3000.000
Y Spd .................................................... 3000.000
Z Spd .................................................... 1800.000
Home Direction
X Dir ..............................................................Neg
Y Dir ..............................................................Neg
Z Dir ............................................................... Pos
Max Speed Limit
Unit MM/Min.
X-MaxSpd ............................................... 6000.00
X+MaxSpd .............................................. 6000.00
Y-MaxSpd ............................................... 6000.00
Y+MaxSpd .............................................. 6000.00
Z-MaxSpd ............................................... 6000.00
Z+MaxSpd .............................................. 6000.00
Toolset Setup
C.A.D. Thickness
FlrHght ...................................................... 15.000
C.A.D. Pickup
PckupHgh ................................................. 10.000
-23-
Advertisement
Table of Contents
