Uploading & Running G-Code - Grizzly G0931 Owner's Manual

Uploading &
Running G-Code
IMPORTANT: DO NOT use a USB drive larger
than 16GB. The controller is designed to read
USB drives formatted below 16GB.
Running G-Code From USB Drive
1. Turn machine ON.
2. Insert USB drive loaded with G-code into
controller (see Figure 26).
Controller
Figure 26. USB drive connected to controller.
3.
Press RUN/PAUSE and scroll to "UDisk File",
then press OK.
4.
Scroll to desired G-code file and press OK.
5.
Screen will display "SetWorkParam" and the
following parameters:
— WorkSpd (feed rate in mm/sec.).
— FastSpd (movement speed between cuts
in mm/sec.).
— SpdScale (spindle speed ratio).
— FallDown (Z-axis speed ratio).
6. Scroll to desired parameter and press RUN/
PAUSE to change value, then press OK.
-32-
7. Press OK again to begin operation.
— Press RUN/PAUSE to pause axis move-
— Press Y+ and Y- during operation to
— Press STOP to completely stop operation.
Uploading G-Code to Controller
USB
Internal Memory
Drive
1. Perform Steps 1–2 of Running G-Code
From USB Drive on this page.
2. Press MENU, then scroll to "Operate File" on
the controller and press OK.
3. Scroll to "Copy File" and press OK.
4. Scroll to "UDisk File" and press OK, then
navigate to G-code file and press OK.
5. Once upload is complete, remove USB drive
and proceed to Running G-Code From
Controller Internal Memory on Page 33.
ment. Spindle will continue to spin. Axes
can be manually moved while paused.
Press RUN/PAUSE again to resume, then
OK to resume from new axis position, or
STOP to return to original position.
manually change spindle speed ratio from
0.1 (stopped) to 1.0 (full speed).
Choose between "Save break" to save
breakpoint to return to later, or "Discard
break" to stop operation without saving.
Resume saved processing through the
advanced processing menu (see Using
Advanced Controls on Page 34).
Model G0931 (Mfd. Since 02/21)