Table of Contents
Advertisement
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Block (Multi-sector Transfer) [Auto]
Enables or disables data multi-sectors transfers. When set to [Auto], the
data transfer from and to the device occurs multiple sectors at a time if the
device supports multi-sector transfer feature. When set to [Disabled], the
data transfer from and to the device occurs one sector at a time. Configuration
options: [Disabled] [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
PIO Mode [Auto]
Selects the PIO mode. Configuration options: [Auto] [0] [1] [2] [3] [4]
DMA Mode [Auto]
DMA Mode [Auto]
DMA Mode [Auto]
DMA Mode [Auto]
DMA Mode [Auto]
Selects the DMA mode. Configuration options: [Auto] [SWDMA0] [SWDMA1]
[SWDMA2] [MWDMA0] [MWDMA1] [MWDMA2] [UDMA0] [UDMA1] [UDMA2]
[UDMA3] [UDMA4] [UDMA5] [UDMA6]
SMART Monitoring [Auto]
SMART Monitoring [Auto]
SMART Monitoring [Auto]
SMART Monitoring [Auto]
SMART Monitoring [Auto]
Sets the Smart Monitoring, Analysis, and Reporting Technology.
Configuration options: [Auto] [Disabled] [Enabled]
32Bit Data Transfer [Enabled]
32Bit Data Transfer [Enabled]
32Bit Data Transfer [Enabled]
32Bit Data Transfer [Enabled]
32Bit Data Transfer [Enabled]
Enables or disables 32-bit data transfer.
Configuration options: [Disabled] [Enabled]
4.3.5
4.3.5
4.3.5
IDE Configuration
IDE Configuration
IDE Configuration
4.3.5
4.3.5
IDE Configuration
IDE Configuration
The items in this menu allow you to set or change the configurations for the
IDE devices installed in the system. Select an item then press <Enter> if you
want to configure the item.
Main
IDE Configuration
Configure SATA As
Onboard IDE Operate Mode
Enhanced Mode Support On
IDE Detect Time Out (Sec)
Configure SATA as [Standard IDE]
Configure SATA as [Standard IDE]
Configure SATA as [Standard IDE]
Configure SATA as [Standard IDE]
Configure SATA as [Standard IDE]
If you want the Serial ATA hard disk drives to use the Advanced Host Controller
Interface (AHCI), set this item to [AHCI]. The SATA controller is set to Native
mode when this item is set to [RAID] or [AHCI]. Configuration options:
[Standard IDE] [AHCI] [RAID]
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
BIOS SETUP UTILITY
[Standard IDE]
[Enhanced Mode]
[S-ATA]
[35]
When in AHCI/RAID
mode SATA controller
is forced to Native
mode.
4 - 1 5
4 - 1 5
4 - 1 5
4 - 1 5
4 - 1 5
Advertisement
Table of Contents
