Table of Contents
Advertisement
6 . 6 .
6 .
6 .
6 .
S e r i a l p o r t c o n n e c t o r ( 1 0 - 1 p i n C O M 2 )
S e r i a l p o r t c o n n e c t o r ( 1 0 - 1 p i n C O M 2 )
S e r i a l p o r t c o n n e c t o r ( 1 0 - 1 p i n C O M 2 )
S e r i a l p o r t c o n n e c t o r ( 1 0 - 1 p i n C O M 2 )
S e r i a l p o r t c o n n e c t o r ( 1 0 - 1 p i n C O M 2 )
This connector is for a serial (COM) port. Connect the serial port module
cable to this connector, then install the module to a slot opening at the
back of the system chassis. The serial port module is purchased
separately.
7 . 7 .
7 .
7 .
C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )
C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )
C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )
7 .
C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )
C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch cable
to this connector. The chassis intrusion sensor or switch sends a high-
level signal to this connector when a chassis component is removed or
replaced. The signal is then generated as a chassis intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted
with a jumper cap. Remove the jumper caps only when you intend to use
the chassis intrusion detection feature.
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
®
P5MT-MX/C Serial Port (COM2) Connector
P5MT-MX/C Chassis intrusion connector
COM2
PIN 1
CHASSIS1
(Default)
3 - 1 3
3 - 1 3
3 - 1 3
3 - 1 3
3 - 1 3
Advertisement
Table of Contents
