3.
Make sure that the drive and bay
hole align as shown. When in
place, the drive protrudes about
an inch from the front panel.
4.
Secure the drive with a screw.
5.
Connect the IDE cable to the IDE
connector on the back of the
drive.
6.
Connect a 4-pin plug from the
power supply to the power
connector on the back of the
drive.
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
A S U S T S 1 0 0 - E 3
I D E c a b l e
I D E c a b l e
I D E c a b l e
I D E c a b l e
I D E c a b l e
P o w e r p l u g
P o w e r p l u g
P o w e r p l u g
P o w e r p l u g
P o w e r p l u g
2 - 1 9
2 - 1 9
2 - 1 9
2 - 1 9
2 - 1 9