Ide Configuration - Asus RS120-E4/PA2 User Manual

5.3.4 IDE Configuration
The items in this menu allow you to set or change the configurations for the IDE
devices installed in the system. Select an item then press <Enter> if you want to
configure the item.
Main

IDE Configuration

ATA/IDE Configuration
Configure SATA As
Primary IDE Master
Primary IDE Slave
Tertiary IDE Master
Tertiary IDE Slave
Fourth IDE Master
Fourth IDE Slave
IDE Detect Time Out (Sec)
v02.58 (C)Copyright 1985-2006, American Megatrends, Inc.
ATA/IDE Configuration [Enhanced]
Allows selection of the IDE operation mode depending on the installed operating
system (OS). Set to [Enhanced] mode if you are using native OS, e.g.
®
Windows Server 2000/2003. Set to [Compatible] mode if you are using legacy OS,
e.g. Windows ME/98/NT, MS-DOS.
Configuration options: [Disabled] [Compatible] [Enhanced]
The Configure SATA As and Fourth IDE Master/Slave items appear only when
you set the ATA/IDE Configuration to [Enhanced] mode.
Configure SATA As [IDE]
Sets the configuration for the Serial ATA connectors supported by the
Southbridge chip.
If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, set this item to [IDE].
Set this item to [RAID] if you want to create a RAID volume from Serial ATA
hard disk drives.
Place a jumper cap on pins 1-2 of the RAID_SEL1 jumper to use the LSI Logic
Embedded SATA RAID Utility (for RAID 0 or RAID 1 configuration; supported
®
on Windows
to section 4.2 Jumpers for details.
Place a jumper cap on pins 2-3 of the RAID_SEL1 jumper to use the Intel
Matrix Storage Manager (for RAID 0 or RAID 1 configuration; supported on
®
Windows 2000/2003 Server/XP).
ASUS RS120-E4/PA2
BIOS SETUP UTILITY
[Enhanced]
[IDE]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
[35]
2000/2003 Server/XP and Red Hat
Options
Disabled
Compatible
Enhanced
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
®
Enterprise ver. 3.0). Refer
®
5-15