Enable Character - Datalogic QuickScan I QM2131 Product Reference Manual

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
To set this feature:
Determine the desired character or value. A setting of 0xFF indicates the the
Enable Character is not used (not available).
1. Determine the desired character or value.
2. Use the
find the hex equivalent for the desired character/value.
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Program-
ming Mode.
4. Scan the bar code: SELECT ENABLE CHARACTER SETTING.
5. Scan the appropriate two alpha-numeric characters from the keypad in
Appendix D,
above. The second character will cause a two-beep indication.
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
Mode.
This completes the procedure. See
this feature.
Table 11. Enable Character Setting Examples
STEP ACTION
1 Desired character/value
2 Hex equivalent
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT ENABLE CHARACTER VALUE SETTING
Scan Two Characters From
5
Appendix D, Keypad
6 Scan ENTER/EXIT PROGRAMMING MODE
284
Setting to previously defined characters such as XON, XOFF, or
host commands conflicts with normal operation of these char-
acters. 8-bit data is not recognized when the option Data Bits
NOTE
on page 27 has been set as 7 Data Bits.
ASCII Chart on page 351
Keypad, that represent the desired character/value in step 2
EXAMPLES
'e'
0x65
'6' and '5'
on the inside back cover of this manual to
Table 11 for some examples of how to set
'}' 'E'
0x7D 0x45
'7' and 'D' '4' and '5'
QuickScan™ I QM21X1 / QBT21X1
Enable Command
Not Used
0xFF
'F' AND 'F'