Table of Contents
Advertisement
INTRODUCTION
This is a neatly designed combined 100mm belt and
200mm disc sander. Unusually, both functions are driven
directly from the motor spindle, with no belts to worry
about. Both functions have a decent size worktable which
pivots from 0° to - 45°, the disc table incorporating a mitre
fence running in a slot for bevel and compound angle
sanding.
The sanding platter also moves from vertical to horizontal,
suiting the task in hand. The belt has close fitting guarding
PACKAGING
HAVING UNPACKED YOUR SANDER,
PLEASE DISPOSE OF THE PACKAG-
ING PROPERLY. THE PACKAGING IS
BIODEGRADABLE.
GENERAL INSTRUCTIONS FOR 230V MACHINES
The following will enable you to observe good working
practices, keep yourself and fellow workers safe and
maintain your tools and equipment in good working order.
WARNING!! KEEP TOOLS AND
EQUIPMENT OUT OF REACH OF
YOUNG CHILDREN
KEEP WORK AREA AS
UNCLUTTERED AS IS PRACTICAL.
UNDER NO CIRCUMSTANCES
SHOULD CHILDREN BE ALLOWED
IN WORK AREAS.
Mains Powered Tools
• Tools are supplied with an attached 13 Amp UK 3 pin plug,
fitted with 10 amp fuse.
• Inspect the cable and plug to ensure that neither are
damaged. Repair if necessary by a suitably qualified
person.
• Do not use when or where it is liable to get wet.
Workplace
• Do not use 230V a.c. powered tools anywhere
within a site area that is flooded.
• Keep machine clean.
which helps this machine achieve a high level of dust
extraction. There is a powered fan in the dust outlet port,
which helps produce an airflow around both the belt and
disc. When connected to a simple vacuum extractor almost
total dust extraction can be achieved. The chassis is heavily
constructed to support the tables and belt arm, a cast iron
base absorbs vibration and has locating holes for securing
this sander to a workbench if you so wish.
Having opened the box, remove the top packaging and lift
the machine out and place upon a clear flat surface, taking
care not to trap or pinch the power cable under the chassis.
Remove the remaining items from the box and place safely
aside.
• Leave machine unplugged until work is about to
commence.
• Always disconnect by pulling on the plug body
and not the cable.
•
Carry out a final check e.g. check the cutting tool
is securely tightened in the machine and the
correct speed and function set.
•
Ensure you are comfortable before you start work,
balanced, not reaching etc.
• Wear appropriate safety clothing, goggles, gloves,
masks etc. Wear ear defenders at all times.
• If you have long hair wear a hair net or helmet to prevent
it being caught up in the rotating parts of the machine.
• Consideration should be given to the removal of rings
and wristwatches.
• Consideration should also be given to non-slip
footwear etc.
• If another person is to use the machine, ensure they are
suitably qualified to use it.
• Do not use the machine if you are tired or distracted.
• Do not use this machine within the designated safety
areas of flammable liquid stores or in areas where there
may be volatile gases.
• Check cutters are correct type and size, are
undamaged and are kept clean and sharp, this will
maintain their operating performance and lessen the
loading on the machine.
• OBSERVE.... make sure you know what is
happening around you and USE YOUR COMMON SENSE.
4
Advertisement
Table of Contents
