Table of Contents
Advertisement
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
3. Watch the procedure
A video of this procedure is available at YouTube:
PLYV5R7hVcs-B2y7oAb54mfyuLrIusa_qE
To install a hot-swap fan, complete the following steps:
Step 1.
Align the fan over the fan slot in the fan cage assembly.
Figure 48. Hot-swap fan installation
Step 2.
Insert the fan into the fan cage assembly until it clicks into place.
Attention: When replacing a fan with power on, complete the replacement within 30 seconds to
ensure proper operation.
After installing the hot-swap fan, complete the following steps:
1. Reinstall the top cover (see
2. Install the server in the rack.
Front VGA assembly replacement
Use this procedure to remove or install the front VGA assembly.
Remove the front VGA assembly
Use this procedure to remove the front VGA assembly.
Before removing the front VGA assembly:
ThinkSystem SR850P Maintenance Manual
64
49).
.
"Install the top cover" on page
"Safety" on page iii
https://www.youtube.com/playlist?list=
134).
and
"Installation
Advertisement
Table of Contents
