Table of Contents
Advertisement
Insert LOM adapter into this slot (see
adapter slot on the system board and
installation of the LOM adapter).
5
AC power LED:
Each hot-swap power supply comes with an ac power LED and a dc power LED. When the ac power LED is
lit, it indicates that sufficient power is being supplied to the power supply through the power cord. During
normal operation, both the ac and dc power LEDs are lit. For more information, see
on page
139.
6
DC power LED:
Each hot-swap power supply comes with a dc power LED and an ac power LED. When the dc power LED is
lit, it indicates that the power supply is supplying adequate dc power to the system. During normal operation,
both the ac and dc power LEDs are lit. For more information, see
7
Power-supply error LED:
When the power-supply error LED is lit, it indicates that the power supply has failed.
8 9
Power supply units:
Install power supply units to these bays, connect them to power cords. Make sure the power cords are
connected properly. Following are the power supplies supported by this system:
• 750-watt platinum power supply
– Input power 115V or 230V ac
• 1100-watt platinum power supply
– Input power 115V or 230V ac
• 1600-watt platinum power supply
– Input power 230V ac
10
System error LED (yellow):
When this yellow LED is lit, it indicates that a system error has occurred. This LED can be controlled by the
XCC. Information provided from the LCD display of the front operator panel could also help isolate an error.
11
Identification button:
Press this button to visually locate the server among other servers. This button is functionally equivalent to
the identification button on the front of the server.
12
Identification LED (blue):
Use this LED to visually locate the server among other servers. XCC can also be used to turn this LED on and
off. This LED is functionally equivalent to the identification LED on the front of the server.
13 14
USB connectors (USB 3.0):
Connect a USB device, such as a USB mouse, keyboard, or other device, to any of these connectors.
15
Serial connector:
"System-board connectors" on page 25
"LOM adapter replacement" on page 69
for the location of the LOM
for information about the
"Light path diagnostics"
"Light path diagnostics" on page
.
Chapter 2
Server components
139.
23
Advertisement
Table of Contents
