Table of Contents
Advertisement
Figure 65. M.2 backplane installation
After installing the M.2 backplane, complete the following steps:
1. Reinstall the PCIe riser-card if necessary (see
2. Reinstall the LOM adapter if necessary (see
3. Reinstall the top cover (see
4. Reconnect the power cords and any cables that you removed.
5. Install the server in the rack.
6. Power on the server and any peripheral devices.
Remove an M.2 drive from the M.2 backplane
Use this procedure to remove an M.2 drive from the M.2 backplane.
With M.2 backplane removed, complete the following steps to remove an M.2 drive from the M.2 backplane:
Step 1.
Press both sides of the retainer and slide it backward to loosen the M.2 drive from the M.2
backplane.
Figure 66. M.2 drive removal
Note: If your M.2 backplane has two M.2 drives, they will both release outward when you slide the
retainer backward.
"Install the PCIe riser-card assembly" on page
"Install the LOM adapter" on page
"Install the top cover" on page
70).
134).
.
Chapter 3
Hardware replacement procedures
89).
75
Advertisement
Table of Contents
