Click on the Save button.
Registering phone
This chapter describes how to register Polycom phone using Hostname or IP Address, or DNS
SRV.
The following topics are covered:
Hostname or IP Address
DNS SRV
Registering your device
A) Line configuration from devices web interface.
To access the web interface of your Polycom phone, first you must know it's IP address on your
network.
To find the IP address of your device please:
Press the Home button.
Go to Settings and press the Select button.
Go to Status and press the Select button.
Go to Network and press the Select button.
Go to TCP/IP Parameters and press the Select button.
IP address is displayed under IP: e.g. 192.168.8.198
Then in your web browser enter the IP address of your Phone, if everything is OK, you should
be displayed with Password prompt. If your Polycom device is at factory defaults the
password should be 456.
NOTE: Depending on your Polycom device and its firmware, web interface settings may vary.
After you log in, under VIEWS you should select Simple Setup.
Then use the toggling show/hide button to reveal the content of the SIP Server group.
Enter your PBXware IP address into Address field.
Enter 5060 into Port field.
After this has been completed you should then use the toggling show/hide button to reveal the
content of the IP Line Identification
Enter extension into the Address field.
Enter extension into the Authentication User ID field.
Enter extension secret into the Authentication Password field.
Press Save button to preserve changes. Your phone should register after couple of seconds, if
not, please reboot your phone.
Need help?
Do you have a question about the VVX 411 and is the answer not in the manual?
Questions and answers