Mass Storage Device Assembly; Removing The Drive Bezel - Compaq PORTABLE 386 Maintenance And Service Manual
Personal computer with plasma display
Hide thumbs
Also See for PORTABLE 386:
- Network manual (9 pages) ,
- Service & reference manual (77 pages) ,
- Maintenance and service manual (276 pages)
Table of Contents
Advertisement
Chapter 8.16 Mass Storage Device Assembly
To remove the mass storage device subassembly:
1.
Complete the preparation procedure (see Section 8.2).
2.
Remove the rear panel (see Section 8.4).
3.
To remove the drive bezel, place your thumb on the rear side of the
drive bezel.
4.
Pull the drive bezel away from the computer with your thumb.
(Figure 8-38).
5.
Disconnect the following cables (shown in Figure 8-39) from the system
board:
o
Diskette drive data cable
o
Diskette drive power cable
o
Fixed disk drive data cable
o
Fixed disk drive power cable
- Quick Links:
- Power Supply
Hide quick links:
Advertisement
Table of Contents
