Fixed Disk Drive Removal - Compaq PORTABLE 386 Maintenance And Service Manual

Preparation Procedures
Before beginning the removal and replacement procedures, complete the
following steps.
1. Turn off the computer.
2. Turn off the 300/600 Megabyte Fixed Disk Drive Expansion Unit (hereafter
referred to as the fixed disk drive expansion unit).
3. Disconnect all power to the computer and the fixed disk drive expansion
unit.
4. Disconnect the signal cable from the fixed disk drive expansion unit to
the computer.
5. Place the fixed disk drive expansion unit on a flat surface with the back
of the unit facing you.
6. Remove the retaining screws from the rear of the unit (Figure 8-106).
7. Facing the front of the fixed disk drive expansion unit, slide the cover
forward until it stops.
Fixed Disk Drive
To remove the fixed disk drive from the fixed disk drive expansion unit,
complete the following steps.
1. Complete the preparation procedures at the beginning of Section 8-30.
Then lift the cover up and away from the unit.