4.
Note: The fingers should be snug enough to
fully support the workpiece at all three points
and also allow free rotational movement of
the workpiece.
5.
Note: After prolonged use, the fingers will
require milling or filing to clean up the contact
surface.
Follow Rest
Figure 31.
Figure 31
Cross Slide
Handwheel Dial Increments
Figure 32.
Note: The cross slide graduated dial is a 2:1 dial.
The amount removed from the workpiece will be
twice the actual distance the cross slide moves.
For example, if you wanted to remove 0.20" from
the diameter of a workpiece, you would move the
cross slide only 0.10".
The metal lathe repre-
sents an entanglement
hazard
parts. Always tie back
long hair, ponytails, loose
clothing, and sleeves, and
remove all jewelry.
Resolution
Figure 32
from
rotating