Grizzly G9972Z Owner's Manual page 44

Feed Rate Gearbox Oil Reservoir
Lubricant Frequency
Tools Needed
To check and add oil to the reservoir:
1.
Figure 67
Figure 67.
2.
3.
4.
5.
Qty
The feed rate gearbox oil must be changed
after the first three months of operation,
then annually after that.
Tools Needed
To change the oil in the reservoir:
Qty
1.
2.
3.
4.
Figure 68.
NOTICE
Figure 67
Note: If you are experiencing difficulty remov-
ing the fill plug, do not remove the drain plug
to drain the reservoir until you can success-
fully remove the fill plug. This way you can still
operate the lathe until the issue is resolved.
Figure 68
Qty