Power Feed - Grizzly G9972Z Owner's Manual

4.
Figure 36
Note: The pulley slots are numbered 1–3
with number 1 being the outside slot.

Power Feed

NOTICE
Feed rate is based on the spindle speed.
High feed rates result in a rapidly moving
carriage. Pay close attention to the feed
rate you have chosen and keep your hand
poised over the power feed lever. Failure to
fully understand this could cause the car-
riage to crash into the spindle or tailstock
resulting in severe damage to the lathe.
Figure 37
Figure 38
Feed Rate Page 32
Figure 39
Note: If the spindle is not turning, you may have
to manually jog the carriage to engage the apron
gearing with the leadscrew.
Figure 39.
NOTICE
NEVER attempt to engage the carriage
power feed (lever up) and the half-nut (lever
down) at the same time. Always disengage
the half-nut (lever up) before moving the
power feed lever up. Otherwise, severe
damage to the lathe could occur.