Grizzly G9972Z Owner's Manual page 32

Figure 36.
The V-belt, change gears,
and pulleys represent
a serious entanglement
hazard when the lathe
is running. Always dis-
connect the lathe from
power before opening
the change gear cover.
Configuring the V-Belt
Tools Needed
To configure the V-belt:
1.
2.
Note: This chart is also on the front of the
headstock. In most cases, the calculated
spindle speed will be between the available
speeds. Use your best judgement when
choosing either a higher or lower spindle
speed.
Qty
Figure 36
3. Figures 37–38
Figure 37.
Figure 38.
Note: There is hex nut on either end of the idler
pulley adjustment stud that is loosened when
adjusting the idler pulley.